Silicone Release (Spray) Agent - ACECO

550 CC

Silicone Release Agent

The release agent is always read for use;

It does not contain any solvent;

No unpleasant odour occurs during spraying;

It can be operated in any position.

A fine mist is obtained which forms a uniform Silicone film on the mould. In vie of the excellent release effect, one application is adequate for several mouldings. The release agent is therefore very economical in use.

Application:

To optain satisfactory results. It essential that the moulds are clean. prior to the first use of silicone release agents, all residues from other release agents should be carefully removed. Apply a thin coat of release agent. The most efficient distance between nozzle and mould surface is about 30 to 50 cm (12 to 20") if the mouldings are to be subsequently printed, varnished or labeled, please contact us, as for such cases special products are avavilable