- Plastic
- ABS
- Acetal
- Acrylic
- Alkyd
- Amino
- Cellulostics
- Nylon
- Polycabrbonate
|
- Noryl
- Delrin
- Polyester
- Plyethylene
- Polypropylene
- Polysulfone
- Rubber
- Urethane Elastomers
|
|
Silicone Release Agent
- The release agent is always read for use;
- It does not contain any solvent;
- No unpleasant odour occurs during spraying;
- It can be operated in any position.
A fine mist is obtained which forms a uniform
Silicone film on the mould. In vie of the excellent
release effect, one application is adequate for several
mouldings. The release agent is therefore very
economical in use.
Application:
To obtain satisfactory results. It essential that the
moulds are clean. prior to the first use of silicone
release agents, all residues from other release agents
should be carefully removed. Apply a thin coat of
release agent. The most efficient distance between
nozzle and mould surface is about 30 to 50 cm (12 to
20") if the mouldings are to be subsequently
printed, varnished or labeled, please contact us, as for
such cases special products are avavilable.
Net content: 550ml
|
